Tips to Replace Car Wiper Blades

508
0
Share:

Windshield wipers need to be regularly inspected and maintained just like any other part of your vehicle. If you don’t have properly functioning wipers, then it is going to be difficult for them to remove the rain and moisture from your windshield. This could make driving dangerous under these conditions because you will not be able to see clearly through the windshield. And if you live someplace where it snows often, bad wipers will put you in even more danger.

So, what does it mean to have bad windshield wipers? Well, the wipers on your vehicle may move back and forth across your windshield, but that doesn’t mean they are functioning properly. You need to concern yourself with the wiper blades the most because they are what actually rub against the windshield and push water off it.

Read also: Blind Spot Detection Technology Working Principle in the Car

Most wiper blades are made from rubber, but others may contain synthetic compounds as well. Gradually, the blades will become weaker and thinner as time goes on. If the blade gets too worn, it will not do a good enough job of removing rain or snow from the windshield. This is when it’s time to get a new set of windshield wiper blades for your car.

Steps to Replace Your Car Wiper Blades

You do not need to be an expert mechanic to change your wiper blades. If you are smart enough to change a tire or replenish your wiper fluid, then you can figure out how to replace your car wiper blades too. Below are the 5 easy steps for doing this.

1) Purchase new wiper blades. Make sure the length of the new blades matches the length of your old blades. You can figure out the length by measuring the length yourself or referring to the owner’s manual. This will tell you the correct size of the blade for your car.

2) You need to take off the old wiper blade. To do this, the wiper has a little tab on its underside that you need to depress. This is the spot in between the wiper and the wiper arm. Once you do this, pull down to slide the blade out until it is removed from the arm.

3) Take your new wiper blade and slide it onto the same arm where you removed the old wiper blade. You’ll want the blade to be on the arm tightly. Keep pulling until a clicking sound is heard. That will mean the blade is locked into the arm. Then you will slowly lower the arm so that it is touching the windshield firmly again.

4) Repeat these three steps with the other wiper blade. When you are finished with both installations, test your windshield wipers by turning them on. You might want to spray your windshield with a hose first so that you can see how well your new wiper blades remove the water.

Share:

Leave a reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.